This week we handed in our sketch 2. Our group managed to finish an awesome scarf, completely hand knitted by my partner Francesca. Sewn in was a small servo motor that was re-programmed to rotate 360 degrees, in order to tighten the scarf comfortably around the wearers neck.
The servo motor that we used was originally intended to only rotate 180 degrees, which was then reprogrammed so that it would go 360 degrees.
there was a thread tied to the wheel on the motor, that would slowly wind around the motor, pulling the inside of the scarf closer to the users neck.
Overall our presentation went well. We were asked to bring the project in again to lecture Wednesday for further inspection, as during our initial presentation the motor had burnt out.
No comments:
Post a Comment